:	Jun 15, 2004

:

The door glass should be lowered by approximately one third.

.

Remove the rear door trim panel.

.

Remove the speaker.   Disconnect the electrical connector.   Remove the 4 screws.

.

Carefully remove the outer waist seal.   Remove the screw.

.

:   Wedge the glass in this position. Using the special tool, release the clip and lift the glass to the top of the door frame.

.

Remove the window motor and regulator assembly.   Disconnect the electrical connector.   Remove the 4 bolts.   Remove the 2 nuts.   Rotate the assembly 90 degrees clockwise, to remove the upper part of the assembly from the rear side of the aperture first.

.

Install the window motor and regulator assembly.   Tighten the bolts and nuts to 10 Nm (7 lb.ft).   Connect the electrical connector.

.

Secure the glass to the glass regulator.   Remove the wedge.   Lower the glass.

.

Install the outer waist seal.

.

Install the speaker   Tighten the screws.   Connect the electrical connector.

.

Install the rear door trim panel.